Squid Triton clone remix - With M3 bolt/nut recesses

thingiverse

This is a remix of the Squid Triton clone by smuf, with recesses for M3 nuts and bolt heads added, so you can use M3 screws and nuts instead of the printed pins. The (trainer) blade remains unchanged. The nuts will not press fit; you must draw them in by tightening an M3 screw from the other side, preferably with the blade in place to prevent breaking the hinge points in the handle. I printed using the following attributes, and the print came out fantastic: * Material: PETG * Layer height: 0.1mm * Infill: 90% * Scaling: 100% PETG has surprisingly low friction in sliding surfaces against itself, so once you've got the tension set on the screws, the knife flips nicely. If your screws are too long, like mine in the photos, cut them down and file them smooth, something I haven't done yet. Note: you must print at 100% scale in order to preserve the M3 cutout sizing. Reducing scale would require you to use either M2 screws and nuts (I don't think they make M2 nuts), or file down your M3 screws and nuts.