Square Led light holder

thingiverse

I required illumination for a small LED aimed at the print head and printing bed while observing the initial layer being printed, yet I failed to notice my specific request on existing websites. Consequently, I created a flexible small LED holder utilizing basic equipment where I utilized a 3 mm thick copper wire. This wire passes through two holes situated at the top and bottom of the design. Installing the upper section simultaneously made it flexible and adjustable, and I wrapped the internal wires with a plastic component from an old desk lamp. The outcome pleased me greatly and proved to be effective, particularly while printing the initial layer. I secured it to the extruder using a T-nut and 3M screw. This was the result. I hope you find it satisfactory.