SQ12 mount - around 30 degree tilt

thingiverse

I adjusted the tilt to around 30 degrees for a more comfortable fit. The other mounts were too extreme, so I opted for this angle instead. Now, the mount has a flat bottom which makes it even more stable. I printed the mount with TPU and noticed some jello effect after securing it to my frame's top plate using zip ties. However, it's a significant improvement over my goggles' DVR. The design should be fine without supports if printed in its current position on its side. Nevertheless, feel free to add supports if you think they're necessary. In the photo with the SQ12, I minimized the weight as much as possible by removing the front IR lights, the weight, and the battery. Then, I connected the power lead to run it off 5v from the FC/PDB for a sleeker setup.