Sq1 Squonk Mod - DNA 75 - 1x18650 - Almost no supports 3D print model

cgtrader

This is a fully 3D printed regulated Squonk Mod that runs on a single x 18650 battery and a DNA75 chip.\nTo get it up and running, you'll also need one Keystone 5209 and one Keystone 228; simply clip them to size, but be aware that using two Keystone 5209 models might just do the trick.\nThe 510 will accept any Squonk 22mm unit; I prefer an 18GA silicone wire for all connections.\nTo keep everything in place, you'll need three x 5mm M3 screws or something similar to hold the chip to the inner slider.\nThe print settings will depend on your specific printer and material of choice; I personally stick with CF20 for the body and PLA for the door and buttons.\nThe body, slide, and buttons can print without supports (face down on the plate), but you'll need some support on the hidden part of the inner slide.\nThe battery/juice bottle door simply clicks into place; if needed, you can add 3mm magnets to the existing holes for a stronger connection.