Sprite Extruder Pro parallel cable harness for Ender 3/Pro

thingiverse

After installing a Creality Sprite Extruder Pro on my Ender 3 Pro, I was frustrated that the only cable management solution I could find for the large ribbon cable was using a zip-tie to attach it to the X carriage where the Bowden extruder used to sit. I designed this as a snap-in part that should fit in place of the old extruder motor. The pins on the diagonal corners should fit into the holes for the screws that held the motor and help to keep the harness from moving. The wiring harness itself hangs off of the side and is curved slightly on one side so as to apply pressure to the ribbon cable. Once installed, place the ribbon cable in the harness and ensure there is enough slack that the print head can move freely along the X carriage. Only a small amount of force from the bottom should be necessary to remove the harness, although this hasn't been tested with materials stronger than PLA.