SprayDosen-Verlaengerung

thingiverse

<font size="4" color="blue"><B>Sprayer Extension</B></font> A trigger extension for sprayers with a diameter between 57 and 68 mm. For extension tubes (handle stems) with a diameter of 25 to 35 mm. Ideal for work around the house or at tents and pavilions (waterproofing). Where the arm cannot reach or a ladder cannot be set up, this extension comes into play. What is needed besides time and a 3D printer? <U><B>Materials list:</B></U> 1 x Print spring (e.g. from a ballpoint pen) 2 x Axis (diameter 3 mm; length approximately 20 mm) 2 x M3 threaded rod ca. 66 mm long 1 x M3 threaded rod ca. 43 mm long 13 x M3 nut 3 x M3 screw x 20 (for centering ring) 4 x M2 nut (for lever roll) 2 x M2 screw x 12 (for lever roll) Do not tighten the screws of the lever rolls too tightly, so that the rolls can still turn. Then secure with a second nut. A little 120-grit sandpaper stuck in the clamp (2 pieces 41x19mm), prevents slipping on smooth tubes/stems. So the clamping screws do not have to be pulled too tight. <font color="red"><B>The parts "<I>Clamp_Screw_Complete</I>", "<I>Lever_Roll</I>" and "<I>Gearbox</I>" should be printed in <U>highest quality</U> and with <U>high fill density</U>.</B></font>