Spray can holder push-pin adjustable mount and union

thingiverse

My kid kept messing with all my spray cans so I spotted this and said, hey, this is perfect! I'll print like 8 of them. And I did, then I looked at the remixes. So I didn't want to drive huge screws into my wall (they have to be big if the cap is going to fit the half-hole mount) and I didn't want to drive even more huge screws into my wall if I wanted to adjust the width of the brackets. The solution? Push-pins and a slide rail! And if you're even more ocd than me, a union so each can has its own custom width, and even a slide rail for the bottom if you don't want any wobble or if you want to make it earthquake-proof. Two push-pins are more than enough to hold the weight of a bunch of cans. If you have big cans, just slide the brackets further apart or closer together for little ones. No need to damage your wall/door/cabinet/whatever else you're hanging these on. Just to clarify, you only need the top piece along with 2 push pins or nails if you don't think push pins will work for whatever reason. The other two pieces are only there if your obsession with perfection drives you further. Also, if you haven't printed a bunch of these already, attached is a version of the bracket without the side tabs since they're not needed with this mount