Spray can handle/trigger (V2 now available)

thingiverse

I made a Version 2 of the spraycan handle/trigger, and it's actually not a planned revision - I was just experimenting with it when I posted it. Someone on a Facebook group asked for a printable handle/trigger for spraycans, but there wasn't much available on Thingiverse, so I decided to give it a shot. This new design prints in one piece without any supports and fits snugly onto the spray can. The benefits are clear: no hardware or supports needed, which is always a plus. However, not all 3D printers have identical tolerance settings, so there's a risk that the handle might not fit perfectly on your machine. To minimize this risk, I've included a small test part for you to print before attempting the full handle. If it fits smoothly, you're likely good to go with the full design. If it doesn't, you won't have wasted too much time or filament printing the entire thing. Other potential issues might arise from the joint fusing together during printing. You can check out a video of this design in action on YouTube here: https://www.youtube.com/watch?v=IxVCsVSmEsw