Spray can handle/trigger

myminifactory

I created this design at the request of a member from one of the many 3D printing Facebook groups I'm actively involved with. This is an all-in-one spray can handle and trigger assembly that I printed without supports, although the curved model may exhibit some surface finish issues due to its complexity. The V2 iteration rectified this issue by removing the curve and adjusting the trigger's angle during printing. Since it relies on a press-fit mechanism, I strongly advise testing the small press-fit tester first to ensure consistent results with your printer. Other potential problems could arise from the trigger fusing with the handle, although I haven't encountered this issue personally. To see the design in action, check out my video below: https://www.youtube.com/watch?v=IxVCsVSmEsw