Spray can gun for ease of work

cults3d

It bloody works (I knew it will, prototyped 10 years ago in metal, cutting and welding... lol) https://www.youtube.com/watch?v=YGmYGoBIHG0 large spary paint jobs are a pain in the ... fingers. So I made up this, I tested in on a 24 cans in a row, about two hours non stop, no pain, nu numbness for hours after, nothing. Technically is two half barrels cut diagonaley, and hinges in a position to transofrm a linear horizontal movement into a linear vertical movement via a roation on an offset hinge, the results are amazing, you press that spray can cap with 10% of the effort, which is also divided between 4 of the fingers, hence about 2.5 precent of the effort taken by pressing the cap with a single finger. I did not had a perfectly fit bolt for this, most were too short, a fw way too long, and this one, a bit too long, but to test it was fine. M6 bolt or 1/4 inch bolt, no problem, long 70-80 mm and one nyloc nut is all you need after you cleansed the prints to hinge the together. Happy spray painting folks.