Spout for 1 Gallon metal can

pinshape

I have trouble pouring Acetone into smaller bottles for ABS juice without spilling it from a 1 gallon can. So I made this device to help. It allows you to slowly pour directly into small containers without spilling anything out. You have to go slow because it doesn't have an air vent. No more spills will happen with this tool. To make it, you cannot use ABS if you plan on using it with any petroleum distillates (including acetone). You might need to sand the base ring on the spout when assembling it because its a tight fit. I created this device with Sketchup and OpenSCAD software. UPDATE: On September 10, 2015, I replaced the spout with a new one that has a flat exit hole to reduce any splashing due to gurgling. To use it, I printed it on a MendelMax 1.5 using PLA and it works with acetone. It did discolor but not dissolve. Some PLA contains additives that are susceptible to acetone so your results may vary.