Spot Hogg Fast Eddie XL compound bow sight - single pin scope triple alignment ring

thingiverse

The primary limitation of this Spot Hogg Fast Eddie XL compound bow sight model lies in its single pin scope lacking a triple alignment ring available for purchase, with only a double pin scope option becoming excessively expensive for an additional non-adjustable pin. To address this need for a triple alignment ring, I designed two versions: one with a rim and another without. To facilitate the printing of these rings on self-adhesive paper that can be stuck directly onto the sight, I have included LibreOffice Draw files, which allow users to adjust the ring colors if desired. These files are also available in PDF format for added convenience. The design is straightforward and does not require any tools to install it on the sight. However, if the ring were to pop off due to vibration, either scaling down its diameter by 1-2% or applying a few small Blue Tack dots inside would resolve this issue. In addition to these files, I have also included a blank sight tape in PDF and LibreOffice Draw formats for users who prefer meters over yards. This can be easily customized according to personal preference. To achieve optimal results when printing: Printer settings should include: - Printer: Wombot - Rafts: Yes - Supports: Yes - Resolution: 100 micron or less - Infill: 25% After printing, support removal is only necessary for the version with the rim. During preparation, I recommend using a drafting compass to cut out the printed rings accurately. This method proves more efficient than hand cutting, which can be tedious and inaccurate. To use this method effectively, replace the pencil lead in the compass with a point, allowing for two cutting points on the compass. Then, gently circle the ring outline several times until it cuts through cleanly without producing ugly edges.