SpoolWorks Scaffold Soluble Support Spool Carrier

thingiverse

This is a Spool Carrier designed specifically to fit inside the airtight bag used to store E3D's SpoolWorks Scaffold Soluble Support. It works with all SpoolWorks 200mm Spools (500g/750g), supporting both 2.85mm & 1.75mm filament. Read the full, detailed blog post about E3D's Scaffold at the Scaffold Blog Post. Print with your favourite thermoplastic at http://e3d-online.com/All-Filament. Consider the Heavy-Duty Air-Tight Filament Spool Case as an alternative. 2 x 608ZZ Bearings are included in the package. Also, you'll need 1 x 1.75mm or 2.85mm Thread Bowden Coupling, 1 x Matched Length of PTFE, 6 x M3 10mm Socket Cap Screws, 6 x M3 Hex nuts, 1 x M8 50mm Socket Cap Screw, 1 x M8 Hex Half Nut, 1 x M8 Washer, and 1 x Rubber O-Ring 10mm ID x 2.5mm. Love 3D printing? Love T-Shirts? Then check out steps-per-mm.xyz! It's loaded with a huge range of wearable parts & components. Please help support my work here on Thingiverse and on Instructables by using the following affiliate links when making purchases: eBay.com, eBay.co.uk, eBay.fr, Amazon.co.uk. Print Settings: Printer: E3D's BigBox Rafts: No Supports: No Resolution: 0.25mm Infill: 15% Post-Printing: Using the Carrier: Slide the spool onto the carrier and load it into the bag, making sure the hole for the bowden coupling is facing towards the bag's opening. Guestimate an approximate place in the bag where it aligns with the hole for the bowden coupling and make a small cut in the bag. Fit the optional O-Ring over the threaded section of the bowden coupling. Screw the coupling into the hole, ensuring a good seal. Attach your PTFE to the coupling, feed in some Scaffold, then seal up the bag. Remember to leave the included packet of silica gel in the bag. You're all set! Happy Printing :)