Spoolholder with mount for 2020 Extrusion I-Type 5

thingiverse

I Recommend You Check Out My New Filament Spool Holder - No Spring The Claw Remake. Why This Model? I Needed a New Spoolholder For My Version Of "Ultimaker 2 Aluminum Extrusion 3D Printer" Http://Www.Thingiverse.Com/Thing:811271 And A Way To Mount It Filament Spool To My Extrusions, So I Created This One. Remix Source I Used The "Low-Friction-Um2-Spoolholder" Https://Www.Youragine.Com/Designs/Low-Friction-Um2-Spoolholder As My Source, But Ended Up Changing Everything. Everything Is Slimmed Down, Reinforced And Basically Reinvented Even Though They Look Pretty Much The Same At A Glance. Changes My Build Does Away With The Center Spacer And Instead Inserts The Bearings From Either End. It Makes For Much Stronger Parts And Eliminates The Risk Of Pushing Out The Ends Of The Pieces If You Overtighten Them. The Finger Nut Has Been Slimmed Down To Make A Less Obtrusive Part. The Inner Spoolholder Have Had Some Finger-Knobs Added To Ease The Tightening/Loosening Action. Edit: 7Th April 2016 Updated Instructions Here. In The Files You Basically Find 2 Models, Where I Consider The First Model As Deprecated - I Keep It As The Source Deprecated Files: Reinforced Center Threadding For Spoolholder 608zz 226mm.stl Reinforced Base With Fingergrib For Spoolholder 608zz 226mm.stl Edit: 7. September 2015: Added A Version Of The Mount Without Middle And Side-Guides. Works The Same And I Recommend Printing With 100% Infill (For The Mount). Added Final Version Of The "Slimmed Nut" Added 3 Spacers Which You Might Want To Use Between The Nut Which Goes Against The Mount And Between The Base In Order To Reduce Friction Slightly. If You Use A Locking Nut, You Want To Use The 5Mm Version. Edit The 13Th September 2015 I Added 2 New Models Where The Base And *Center Parts Are Combined Into 1: Inner Part 6mm-basehole.stl And Inner Part 15mm-basehole.stl The Difference In The Two Parts: The Depth Of The Hole In The Base, Facing Your Printer: One Is 6Mm Deep, Intended For Your Bearing To Sit In There With No Spacer, As It Was From The Source. The Other Is 15Mm Deep. Print Requirements: Holes Are 22.6Mm To Make It Easier To "Install" The 608zz Bearings. Support You Might Need Some Support If You Print The Mount With Middle And Side Guides. BOM: 2x M8 Locking Nuts. (You Can Use Normal M8 Nuts) 1x M8 Normal Nut. Some 8Mm Threadded Rod. 2x 608ZZ Bearings. Using These For Ultimaker 2 Aluminum Extrusion 3D Printer If You Are Going To Mount 2 Filament Rolls You Need At Least One Of The Mounts To Be Without Guides, Or There Is Not Enough Room For Them Vertically.