Spooler holder (by pbannister) Remix

thingiverse

This add-on set is designed to work seamlessly with Spooler holder, a brilliant creation by pbannister found on Thingiverse (https://www.thingiverse.com/thing:2844702). Initially, I was not satisfied with the play in the spool holder - my bearings kept sliding around the inside excessively. To address this issue, I designed an endcap and center bearing spacer to provide a stable platform for two bearings, along with a new mount for the TronXY X5S frame that has been extended to accommodate the spool hold while it's in place. To bring these parts to life, I opted for a 0.2mm layer height and 100% infill when printing the endcap and frame mount. For the center bearing spacer, a more modest 0.2mm layer height and 10% infill were used. In theory, the endcap could be printed with low infill, while the center bearing spacer benefited from its 10% infill. Keep in mind that some parts may necessitate supports in specific areas - it's best to exercise your judgment when deciding which ones require them.