Spool Wall-mount

cults3d

For this print you'll need: 2x - 6001-2RS bearings 4x - D4 Screws to fix it to the wall ( I used 4x30 SPAX) Assembly: Take the two little shafts and glue them into the big Axle with the thread.(be careful with concentricity) After the glue is dry, glue the bearings onto the shafts and let it dry too. While the glue is hardening, you could mount the hooks onto the wall.(or as I did onto a wooden board.) In the files I included a technical drawing of the assembly, where you can find the dimensions for mounting. Print settings: When printing the two wall-hooks, you should definitely use at least 6 or 7 perimeters and at leat >25% infill, to ensure that it won't collapse under the weight of a fresh spool. (I shared my Print-settings as a screenshot for reference) ( I know it's in German, I'm sorry ;D) Same goes for the other two little shafts (these are loaded with the entire weight of the spool on shear), so I would even recommend to print them with 100% Infill, since they're quite small. For all the other parts: you can slice them as you wish, since they won't be put under a lot of load. If you have any questions, problems or just some ideas for improvement, don't hesitate to ask. I'm looking forward to hear your feedback. Furthermore, I'd be very pleased if some of you could upload their prints as makes, as well as sharing your thoughts and impression of the design :D Thanks to all hwo downloaded my design