Spool storing system

pinshape

I store my filament rolls in these brackets for normal-sized spools weighing 0.75 kg. The brackets are designed for easy access, preventing the spools from rolling away. They are extremely sturdy and can hold a large number of spools, as shown in the attached pictures. The brackets are mounted directly to the wall, requiring only two holes per bracket. The pre-drilled holes in the bracket measure 6mm in diameter. To install one bracket, you will need to drill two holes in your wall. Each bracket requires a pipe with a diameter of 15mm or a 5/8" pipe. You can find these pipes at most DIY stores. If using a 15mm pipe, some paper or tape must be inserted between the clip and the bracket for proper alignment. The small clip attached to the bracket is secured with M4 screws in Europe or 4mm bolts elsewhere. To use these brackets, you will need: * A 15mm pipe or a 5/8" pipe * Two wall anchors, including plugs and screws (I used 6mm plugs and 4mm screws) * Two M4 screws (10-40 mm in length) To print the bracket, I recommend using 3 perimeters and a 20% infill to ensure sufficient strength. The bracket prints flat on the bed without supports, but it is recommended to use a heated bed to prevent warping. The dimensions of the printed bracket are 140mm x 197.5mm.