Spool mount replacement for k8400

thingiverse

Replacement for the original spool holder. The diameter is slightly smaller than the original (~4cm) and also the height is a bit longer (~8cm). Print Settings Printer: Vertex k8400 Rafts: No Supports: Doesn't Matter Resolution: 0.1mm Infill: 22% How I Designed This Instructions Print two models (obviously). Then, use the original nuts and bolts (4 x M3 nuts and 4 x 25mm M3 bolts) to assemble it. You will likely need to adjust one of the bearings to reduce the distance between the two bearings. Since I didn't measure the exact distance, just try with one half until it fits, then tighten the nuts.