Spool holder

thingiverse

Just another filament spool holder with a totally cool biohazard mark! The frame parts should have pretty much infill to make them stiff. I used 35% infill. If you experience problems with warping, try using the "Frame_Brim." The small brims are easily trimmed off with a knife. You can choose how many bearings you wish to use depending on the type of filament spools you have. Simply replace any bearings with Bearing Replacement parts (B_R_x) in any configuration you want. It's actually possible to use the spool holder without any bearings, just using B_R parts, but it will have a little more friction. There should be a M8 washer between every part on the threaded rod. Alternatively, you can print an all plastic version using parts "Holder1" and "Holder2." To build this, you'll need: Printed parts, of course. A piece of threaded rod, 105mm long, 8mm (M8) diameter. Two Nuts (M8). 608 bearings. Washers M8. Print Settings Printer Brand: Prusa Printer: Prusa Steel Rafts: No Supports: No Resolution: 0.2 Infill: 35