Spool holder vertical for 2020 frame printers

thingiverse

This is just a basic universal spool holder setup to go with my 2 piece vertical holder using a piece of 5/16" or 8mm threaded rod and 2 to 4 nuts takes 2 spool wheels and 2 washers to reduce friction on the wheel from the nut still work in progress mounts your spool above the your extruder stepper so it feeds straight down Print Settings Printer: Anet X2 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 25% Notes: i switched to bare glass with a slurry and don't use rafts or brims anymore i did print supports on the big field goal section of holder but may not be necessary i print everything in abs not sure how to adjust for pla or if pla will hold up you will have massage some of the parts i print the spool holder and such scaled up 2% to acount for shrinkage but still have to run a drill bit in holes and do a little sanding to get 2 pieces to fit together but don't want too much slop i then glue them together with my abs slurry but have holes if you wanted to use m3 bolt and nut to hold together