Spool Holder to suite PrintDry spindles.

prusaprinters

The rubber spool holders supplied with my PrintDry did not fit the centres of the filament spools I have been using. this resulted in the spools falling off when printing direct from the dryer, which resulted in a couple of failed prints.These spool holders use the original aluminium spindles and fit spools with 73mm holes and up to 70mm wide.Print instructionsYou will need to print 2 per spindle. 5 walls 15 to 20% infillMaterials to suite your drying temp, see Material Notes belowNo supports requiredMaterial NotesThe PrintDry can heat up to 75 Celsius, I only use 45 celsius so mine are printed in PLA+ with no problem so far. I suspect that if had filament in the dryer for and extended period I would need to reprint in PETG or ABS.