Spool_Holder No supports

thingiverse

Put this together because the inner diameter of one of my spools was a little too small for the holder I was using. Plenty strong enough for 1kg spools. It can hold spools with a 54mm diameter inner hole. 69mm spool width max, can probably push that to 70. I plan on making a second with the same design that can hold wider spools. Suggestions on size are appreciated. This has been printed, tested and will work. Requires: 2x 608 bearings 3x M4*12 bolts 3x M4 Nuts Printing: Print with your preferred settings. 20% infill though I expect 10% is fine. No supports are needed. Standard Quality - 0.2mm With my settings Cura tells me that it takes 5 and a half hours, 11.19m of filament and weighs 33g.