Spool Holder

thingiverse

This table top spool holder utilizes an M10 threaded rod along with 2 M10 washers and 3 M10 nuts. It features a 48mm 'bearing' that fits onto a RRW 50mm spool, while also including a larger 52mm 'bearing' for accommodating bigger spools. To assemble, print the table stand and two identical-sized spool bearings. Attach two nuts to one end of the M10 rod and tighten them so they are 25-29mm from the table when inserted into the stand. Place a washer between the lower nut and the table stand top. Add a washer and one bearing on top of the nuts, followed by the spool, then place the final bearing atop the spool and secure with a M10 nut. If necessary, clean the 10mm hole in the table stand with a drill for smooth rod movement.