Spool holder inside lack table enclosure for Prusa Mk3

thingiverse

Spool holder mount on the PSU bracket that replaces the original PSU on MK3 for the lack table enclosure. I wanted to avoid having the spool sitting atop the table, so it's positioned on the right-hand side, inside the enclosure with a 45-degree angle, squeezed between the leg and the MK3 frame. This design is essentially a remix of Filarollslider bearings by Bagwan. To secure the spool holder in place, I'm using M3 screws approximately 20mm long along with M3n nuts (hexagonal). Two holes were drilled into the bracket to accommodate the mounting hardware.