Spool Holder for Printrbot Maker (1405)

thingiverse

This is printable on the standard maker/simple 4x4 bed. The hole pattern for the simple will probably not support this design. This is a set of mounts to hold a 3/4 in PVC pipe to the side of a printrbot for hanging a spool over top of the printer. You should just need a short chunk of PVC and an elbow. The screws on the side of the bot will just barely grab the nut so be sure their heads drop down into the cutout for them. V2 Is not an accurate file! If you have it don't print it. I messed up the spacing of the holes when i tried to make the bracket bigger. V3 puts the holes back where they are supposed to be and puts the pipe 5mm further off the side of the printer Instructions there are 4 screws on the side of the bot outside of the case that houses the X and Z motors. These will be used to mount the brackets. Be sure they thread in, the fit is tight so you may need to push the nuts forward with a screwdriver so they start to thread.