Spool holder for 2020 Extrusions (Deltas)

cults3d

Spool holder for 2020 extrusion Delta. It's designed to work seamlessly with any 2020 frame, but the spool holder comes off at a 30 degree angle to counteract the delta frame's natural tilt. *Note that the M3 nut can be quite tricky to get onto the bolt due to its deep placement within the spool holder arm. To overcome this challenge, I used a little superglue on the end of a sharpie tip (with the cap securely in place), which allowed me to start the process. Then, I employed a flat blade screwdriver to tighten it up snugly.* If you need to make any adjustments or modifications, I can provide the CAD files for your reference. Required components: 2x F623zz bearings 1x M3 bolt (at least 35+mm long) 1x M3 nut It's highly recommended to use loctite or a nylock to secure the nut in place and prevent it from loosening over time.