Spool Holder CR-10s PRO, CR-10s PRO V2

thingiverse

This is an adjustable spool holder with bearings in the wheels. The main body with rollers slide on the rails for spool width adjustability. Make sure to feed the filament from the bottom of the roll for extra stability. All that's needed to complete this project is four 608zz (8x22x7) bearings. Uses the stock spool holder t-nuts and screws. I designed the wheels in two pieces for easier printing without supports and easier bearing insertion. Once both halves are pressed on to the bearing, you will never know its two piece. Print the bolts and nuts at .16 and 100% infill. Also print nuts at 111% on the x and y axis only. Put a shim on each side of the bearing on the bolt (axle). Works with: https://www.thingiverse.com/thing:4692005 Print: 2-Body 2-Rail 1-Center Body 8-Wheel 8-Shim 4-bolt 4-Nut