Spool Holder

thingiverse

This is a spool holder that I designed. It has enabled me to run my machine faster without increasing the vibration. based on the “name” of the parts note the following: -The name of this part "Inner Part_Spool D=50 L80" means. the inner part in which the actual spool will be connected to has a diameter of 50 mm and a length of 80 mm. I made few configurations of the inner part, because different manufactures use different spool inner sizes. Example: if my spool has an inner diameter of 55mm and a length of 65. I would use an "inner part_spool" that is slightly smaller in diameter and at least 10 mm longer. disclaimer: if you increase your speed significantly above 100 mm/s then the spool might be able to move this holder, i would suggest not going to that extreme but if you do try to but a small structure in front of the spool holder to prevent it from moving. All infill was 20%