Spool Holder

thingiverse

This is a spool holder design tailored to accommodate the standard large filament spools we frequently use. Spool width is irrelevant, and spacing can be adjusted as needed. The purpose of this design is to prevent filament tangling, which would put unnecessary stress on the gantry and result in undesirable z-axis movements that can cause warped prints. To assemble this holder, you'll need to print four wheels, four bottoms, and four side components marked as v2, which will collectively form two bearing holders for one large spool of filament. Not included are your chosen bolts. If you prefer, you can simplify the assembly process by printing only the bottoms and sides, then sourcing bearings from an alternative source; however, these bearings must be under 35mm in diameter and no wider than 10mm. Print Settings: Rafts: Doesn't Matter Supports: No Resolution: 0.3 Infill: 20%