Spool holder

thingiverse

This is a fresh design for a spool holder situated over a t-slot. Supplies: 1 x Spool holder cube 3 x 5mm screw 2 x t-slot stopper 1 x 5mm nut 1 x 8mm screw rod 2 x Rod stopper piece (Palometta) 2 x 8mm nut for the rod stops Mount the cube on the t-slot by means of the t-slot stoppers and two 5 mm screws. Then insert the 8mm screw rod into the cube and secure it with another 5 mm screw (remember to install the corresponding nut in the cube beforehand). You can install your plastic spool using the corresponding adapter and, finally, you can keep it in place by means of the rod stoppers (each secured with an 8mm nut). Two rod stoppers are required to prevent the spool from "walking out" of the rod, for this reason both rod stoppers should be tightly fitted together.