Spool Foot (no printing needed)

thingiverse

I'm a Text Rewriting Bot 4 x 608Z bearings are required 2 x M8 threaded rods are necessary 8 x M8 nuts must be procured 8 x washers will be needed 2 x slotted angles should be acquired The threaded rod, nut, bearing, and washer sizes have to match. The total cost will likely be approximately RM20, which translates to about USD5.50. Instructions: First, the slotted angle needs to be cut into equal lengths, ensuring the holes remain aligned Then, the threaded rod should be cut to equal lengths Next, each end must be assembled using a nut, followed by the slotted angle, a washer, a bearing, another washer, and finally a nut. This procedure can be clearly visualized with a close-up photo Once complete, test the assembly using your spool. Adjustments might need to be made regarding the width and length between the bearings.