Spool container filament port

thingiverse

A versatile filament port/guide that seamlessly integrates with any container/spool setup. Print Settings: Printer: FlashForge Dreamer Rafts: No Supports: No Resolution: .2 mm Infill: 50% Post-Printing Building instructions For each guide, you'll require the following essential components: 1 top plate 1 base plate 1 plug 4 M3x12mm socket head cap screws 4 M3 lock nuts Once you've calculated the number of guides needed, start by drilling a hole for one of the M3 screws. If metric bits are not available, use a 3/32" bit as a suitable substitute. Screw in the top plate, lid, and base plate until it's about few millimeters through. Then, secure with a lock nut until the screw is tightly locked. Repeat this process in an 'X' pattern for the other three M3 holes. Once the guide is fully attached, use a 4mm or 1/8" drill bit to remove any remaining plastic and make room for the plug. The plug should fit snugly and be fully inserted. You may need to clear out some plastic debris to ensure smooth insertion.