Spooderbox. Small creature enclosure.

thingiverse

 ___________________________________ Spooderbox ============================== Small Animal Enclosure. ----------------------------------- ______________________________________________ [](https://discord.gg/nHr7RV5) __________________________________________ [](http://bit.ly/2LMBt19) [Polish shop here.](http://bit.ly/2Xu2uIA) __________________________________________ [](https://www.facebook.com/3DPrintSlav) ____________________________________ [](https://paypal.me/BlackHideki) ______________________________________________________________ Quite simple and modernistic animal enclosure, requires 3 glass panes (one extra optional), some silicone, and a small animal. Needed Parts: - 3 glass panes the size of 154x154 (+-1mm) and max thickness of 4mm (3.5 max recommended). - Aquarium/Food grade silicone - Optionally a 135x50mm glass pane. Instruction: Print all parts. Depending if you want windowed hatch or windowless one print a proper version. When needed print with supports from buildplate only. Print a Spooderbox vent with no top and bottom layers, dense infill, and 4+ walls. Infill structure will act as a vent holes, make sure they are small enough to not let your animal escape. Slide into a base and glue using a silicone 2 side glass panels. Slide front panel in but do not apply silicone there, its design to be an entry point that you can slide in and out at will. Glue vent to a Spooderbox top using silicone or other glue. Use silicone to glue Spooderbox top to a base, remember to not glue fron glass panel to anything and make sure you can slide it in/out. Optionally glue smaller glass pane to a hatch, or use windowless hatch. When all silicone sets fill enclosure with decor of your choice, and let your animal in, slide front panel in and close everything using top hatch. Cubone skull I used as a decor can be found here: https://www.thingiverse.com/thing:2839481 I sized it down to around 5 cm.