Spontex Garage - Kitchen Sink

thingiverse

Get your dish washing sponge out of the marsh with the Spontex Garage! Includes: Sponge holder ("garage") Magnet aligner Mount: * A strip of iron is glued to the backside of the sponge holder. I recommend a pair of galvanized shims. Ideally 20mm diameter. * The magnets are placed on the opposite side of your kitchen sink. Sink must be thin enough for the magnets to pull the shims. * Add dual sided tape to the aligner. The groove/recese is to compensate for thicker tape if you need to - You'll want your magnets as close as possible to the outside of the sink. Slicing/Printing: * Garage: Angled bottom surface flat to the bed. Your printer should be able to do a 55° overhang - most stock printers go "clean" as low as 45° * Magnet aligner: Upright or laying down and magnets openings facing up Requires 2 neodim magnets. Ideally 20x10x5mm. Anything else will also work.