SpongeBob SquarePants Sponge Holder

thingiverse

I've designed this to be printed with separate parts for easy multicolor finished piece. The arms and hand rotate and water drains out the legs. Use a fine print setting. Use 35 to 25% infill with the Shirt and pants and shoes. Use 100% infill with all the rest of the parts. Use Tree supports when needed only touching build-plate, if you use supports everywhere you'll have a hard time cleaning out the sockets for the shirt, shoulders, arms, and hands. Use a solvent adhesive to glue the legs into the pants. Slide the small white sock band on first then the blue band, then the medium white band, then the red band, then use adhesive on the part of the leg the largest sock part goes on the slide on making sure it's level with the bottom of the leg. when glue is set apply glue to inside of shoe socket slide on to sock place quickly. Use a Q-tip to make sure leg pip is free of glue. Repeat for other leg. For shoulders, arms and, hands gently heat the socket with a heat gun and, then quickly slide the ball into the socket. You may have to reshape the front part of the socket because the ball will deform it slightly as you pushes through. Just use your fingers to push it down around the shaft. The tie will push on with firm even pressure same for the bels pieces.