Sponge Stool

thingiverse

I printed this without supports, and to my surprise, it actually survived with minimal damage after some post-processing work. However, I would not recommend following in my footsteps; there was a significant amount of string to clean up afterwards. To avoid similar problems, use supports, print at a slower pace, and utilize software optimization tools for the model. I suspect that I left too much detail either in the .stl or my G-code settings. Despite this, the final product still looks great, but if you slice it incorrectly or fail to optimize it properly, your printer will likely pause over the tips of rounded surfaces. If you optimize the model and print it correctly, it should turn out flawlessly. Any issues will become apparent during the first layer. I printed mine using a nice yellow PLA filament, which looks particularly cool in other bright colors as well. Expect to see some real-life photos of my finished product soon. To ensure that this stool can safely support more than 120 pounds on a good day, add some permanent thick supports between the two layers of the seat and between some of the legs. This will significantly enhance its structural integrity and make it much safer. I didn't take this precaution, and I'm worried that it might break under my weight one day, despite feeling sturdy so far. It's not as structurally ideal as it could be with a few small permanent supports. If you print this without supports on PLA filament, don't blame me if you get hurt; I'm fine for now, but I'll keep you updated if it breaks on me.