Spoke magnet holder small

prusaprinters

<p>Spoke magnet holder for 8x3mm round magnet.</p> <p>M3 screws 5 to 10mm should fit.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>I3 Mega</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>Doesn't Matter</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.1</p></div> <p><strong>Infill:</strong></p> <p>10</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Printed at 108% in Cura worked best.<br/> you should use a brim. <h3>Post-Printing</h3> <p><strong>install on spoke</strong></p> <div><p>hotglue the magnet in.<br/> heat the spoke up a little with a lighter then tighten the screws. <p>Tapping the hole may be necessary.</p> </p></div></p></div></p></p> Category: Sport & Outdoors