Split Blade Sword

thingiverse

My kid caught sight of this split blade used by Elektra in Iron Fist and asked me if I could print one out. This is my very first design in Fusion 360 and it was quite a steep learning curve, but I'm pretty happy with how it turned out. The sword snaps together with eight 6x2mm magnets that fit perfectly into place. I used welding wire to stiffen up the blades and added some foresightful slots, but surprisingly, it works just fine without them too. There are a few extra smaller slots available to reinforce the joint if needed. You can print two pieces at once diagonally on a 300X300 print area. The total length is around 560mm. The first picture is a GIF file. Just expand your view and check out the original file, then the GIF should work just fine.