spitvalve (waterkey) replacement for Allora Aere plastic trombone
prusaprinters
Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.Print SettingsPrinter:Sovol SV01Rafts: NoSupports:NoResolution: 0.1 mmInfill:100%Filament:CC3D PETGRed Notes: Installation instructions:Install the lever on the trombones slider by pressing it against the spring and lining up the axle hole. Slide in the axle. Lift the lever while holding the slider with the drainage hole pointing downwards. Put a small dollop of cyanoacrylate superglue on the corresponding surface on the lever. Turn the slider upside down while holding the lever lifted.Place the half sphere stopper on the seal of the drainage hole.Place a small dollop of polyurethane gorilla glue on the flat surface of the stopper. Release the lever allowing the spring to squeeze it against the stopper. Wait a couple of hours for the bond to form between the two parts. Category: Music
With this file you will be able to print spitvalve (waterkey) replacement for Allora Aere plastic trombone with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on spitvalve (waterkey) replacement for Allora Aere plastic trombone.