Spirited Away Bath Tokens and Mobile

thingiverse

I modeled this mobile based on the movie Spirited Away. The ten different _tokens_ are 15 x 5 x 0,5 cm (length x width x height, **conversion to imperial below**). There are three _rings_ that I've modeled. I wanted to use the small (Ø15 cm) and the large (Ø22 cm) one, but the large one was too big for my printer, so I modeled a medium one (Ø20 cm). You can install 7 tokens on the large/medium rings and 3 tokens on the small ring. There are three small holes in each ring to hang up the mobile (I used a clear nylon thread). I printed the tokens with a white filament and painted them by hand. The rings are printed with a marbled filament, but you can use whatever filament you like. The purple ribbon I used to connect the tokens to the rings is 2,5 cm wide. I chose the purple colour because of references from the movie (visit the Ghibli Wiki for screenshots, references, etc.). **Conversion of the dimensions** 0,5 cm = 0.2″ 2,5 cm = 1″ 5 cm = 2″ 15 cm = 5.9″ 20 cm = 7.9″ 22 cm = 8.7″