Spiral Wave Flower Bonsai Pot

thingiverse

Flower Pot/Bonsai Pot with Walls of 12 mm Thickness. There are Five Holes in the Bottom for Proper Drainage, One in the Center and Four Around the Edges. This Object is Not a Vase Mode Object. Measurements: The Pot Measures 213 mm Wide by 118 mm Tall, Has 12 mm Thick Walls, and a 12 mm Thick Bottom. Infill Must Be Used During Printing. A Standard Infill of 15-20% Is What I Typically Use. Supports: I Have Tested This Pot with a 60 Degree Angle and No Supports Were Necessary. However, If You Experience Issues with Bottom-Outward Growth from the Initial Layer Drop, Try Setting Your Supports to 40-50 Degrees to the Bed Only. This Will Add a Small Amount of Support Around the Very Bottom Edge of the Pot Where It Starts to Rise Off the Bed. If You Encounter Problems with the Waves on the Vase, Lowering Your Supports to 40 Degrees May Help. The Slicer Will Then Place Supports at the Major Turn-Back of the Wave, Adding Minimal Number and Making Them Easy to Remove. If You Resize or Reshape This Pot in Your Slicer, Be Sure to Check for Required Supports. As Is, the Wave Action Does Not Require Them, but Shrinking It Down Along the Z Axis May Cause the Waves to Become More Pronounced, Requiring Additional Support. Happy Printing!