Spinning Rings Quiet Fidget

thingiverse

Quick print (1 hr on Ender3) fidget I altered the script slightly so that there would be a smaller gap (and therefore would resolve the issue where the rings would fall out easily) for rings v2.stl See remix citation for the original script Parameters: outer_radius = 2.5 ring_width = 0.25 pin_inset = ring_width * 0.6 hole_inset = ring_width * 0.8 ring_height = 0.5 gap = 0.1 #this is the altered parameter# num_of_rings = 4 vertices = 120 #If you go for low vertices make sure to match the angle so pins go into corners (else it's not a circle and formulas don't work). Update: Initially the above performed well but my last print I found one of my prints was still a bit loose so I updated the gap to 0.09 for rings v3.