Spinning Clay Target Holder

thingiverse

Here's a tool for holding 8 clay targets using a device found at this link: https://www.thingiverse.com/thing:2369862 A DXF file is attached, with design dimensions given in inches. To size the DXF properly, set the diameter to 14 inches (excluding the "T"). Refer to the pictures for further clarification. To assemble the device, use a 1/8-inch router bit for the "T" pocket and screw holes, while using a 1/4-inch router bit for all other cuts. A video demonstrating the assembly process can be found at this link: https://youtu.be/t3_L0ax7ErU The following materials are required: - A 15x15x1/2 inch wood board or plywood - Two 608 bearings - One 1/4-inch coarse thread screw, 5 inches long - Five 1/4-inch hex nuts - Eight #8 x 3/4-inch wood screws - Sixteen elastic bands - A suitable pole to attach the wheel to CNC cutting is recommended. Cut the "T" shape only 1/4 inch deep to create a pocket for the skeet holder STL file, then cut out the rest of the wheel. Print the spacer STL file since the 1/4-inch bolt is smaller than the inner diameter of the 608 bearing. Use the smaller wooden circles to hold the bearings in place, securing them with #8 wood screws. The skeet holders fit snugly into the pocket but are held in place using elastic bands.