Spinner with enclosed weights

thingiverse

Spinny fidget thing that snaps together quickly and easily. The center button is a slightly modified version of the spinner_pin_notch found at http://www.thingiverse.com/thing:2108748, which snaps together perfectly well. However, it's not flawless but I'm leaving it as it is. Print Settings Printer: DIY Kit Rafts: No Supports: No Resolution: 0.1 mm Infill: n/a Notes: I haven't tried printing at anything over 0.1 mm resolution so far, and it may not work at higher resolutions. However, PLA seems to work fine. Post-Printing Six 1/2 inch wide nuts are required to assemble the spinny fidget thing. Press all the parts together firmly until they fit snugly. There's a bit of slop in it that I'm still working on but this came out alright so far. First, add the nuts and then push the ring into place. Press the other piece on firmly. To get it to snap into place, sandwich it between your hands and squeeze it gently until it pops into place. Next, press the bearing into its designated spot using an old 15 mm socket. A bench vise comes in handy here to provide extra leverage and make the process easier.