Spindle loop addition to Tomas' 100% Printable Clamp (Not only for Nipples! :-)

prusaprinters

A very quick remix of one of the parts in Tomas' 100% Printable Clamp (Not only for Nipples! :-) to add a loop for attaching cord or chains.This is only the spindle part, so please see Tomas' original model for the other 3 parts you will need.  I've found his 104% wide screwnut to fit the best, but YMMV.I printed it with 0.16mm layer height, standing up with the flat surface on the bed, support enabled (touching buildplate only) to ensure the key portion of the spindle is nice and flat.  I also used a brim to ensure the support section was laterally supported (somewhat ironic).  Again though, YMMV so you should use whatever print settings you think would work best for your particular set up. Enjoy!