spiggytech portable chassis for ASRock X300M-STX

prusaprinters

Revisiting a concept I made about a month ago, I started from the ground up on a new design piece. The design directed I wanted to move towards was to give it a large amount of activity when assembling the case, so that there would be an unusual amount of movement. This is for the ASRock X300M-STX Motherboard that comes from the DeskMini X300Assembly Manual will be added later.Case is printed in PLA+  Materials: 4x  M3x6mm for the mobo standoff anchors4x  M3x6mm for the standoffs4x M3x6mm screws for holding the mobo 20x M3x8mm screws for holding the chassis together2x M3x8mm screws for holding the power button4x M3x10mm screws for holding the carry handle hinges2x M3x8mm screws for additional strength to the carry handle hinges2x M3x8mm for capping the carry handle to the hinges Updated 2/8/2023: Some small adjustment to the IO panels. The rear IO's Antenna holes are enlarged slightly for quicker install. Front IO's button has been flattened so it can be printed face down for a textured front. Likewise there's some tolerance adjustment to front IO components.