Spice shelf (Warning! Bridging torture built in!)

prusaprinters

<p>Warning! Make sure your printer can handle long bridges before printing!</p> <p>This is a three shelf model measuring 250 mm wide 150mm front to back and 100mm tall.</p> <p>I would suggest printing with a brim.</p> <p>Other than that no supports are needed,</p> <p>I've added two support pillars in the middle that can be removed afterwards.</p> <p>Much bridging will be done and the underside may not look pretty!</p> <p>The side walls are approximately 2mm so bear that in mind if scaling.</p> <p>It may be a long print.</p> <p>I would suggest</p> <p>.25mm layer height</p> <p>1.2mm shells</p> <p>1.2mm top and bottom.</p> <p>20% infill</p> Category: Household