Spice rack

prusaprinters

<p>This is a spice rack which uses 1/4" (6.35mm) dowels. There is a slot on the back side of the bracket so it mounts flush when using a 3M Command Strip. The brackets are narrow so the command strip needs to be cut in half lengthwise. If you don't have any Command Strips, any double-sided foam adhesive tape should work.</p> <p>It should fit all standard size spice jars.</p> <p>Directions:</p> <ol> <li>Print one of each side</li> <li>Cut 3 dowels to the same length</li> <li>Glue the dowels into the holes (I used hot glue)</li> <li>Apply command strip to the slot on the back of each bracket</li> <li>Apply to your cabinet door</li> </ol> <p>Update 2021-03-36: After 2.5 years, one of the command strips let go, so I redesigned the base to accept full width strips for better hold.</p> <p>Update 2020-08-16: Added version for use in the center of the rack. Thanks @xaviervilla for the idea of making a version with the holes all the way through for use as a center support.</p> Category: Organization