Spektrum Firma 130/150/160 esc power switch rollcage mount for Arrma 6s vehicles

thingiverse

These mounts are designed for the Spektrum Firma 130/150/160 esc power switch and attaches it onto the side of the center roof/roll cage support (Part #ARA320273) used in the Arrma 6s Kraton/Notorious/Outcast/Mojave/Senton vehicles. <b>There are two versions of this mount to choose from:</b> 1.) The Upper position version attaches using the top and bottom screw mounts on the front of the roll cage on motor side. Use this version if you are using a larger esc fan adapter on top of the esc, otherwise there may be issues with clearance. 2.)The Lower position mounts slightly lower than the Upper position version and uses the bottom two screw holes located on the front of the cage on the motor side. Depending on your ESC mounting position the top mount may stretch the power switch wire too much so if this is the case then I recommend using the lower mount. Note that if you are using a larger ESC fan adapter then the lower position switch mount may have clearance issues. <b>Materials Required:</b> (1) M3x16mm or longer screw (top screw) (1) M3x6mm or longer countersunk screw (bottom screw) <b>Tips to get the switch into the mount:</b> Slide the switch into the mount wire side first from the upper side of the mount. The mount has a channel to make room for the little plastic nub that is on the underside of the switch, however this nub can make it sliding into the mount difficult to start. I found it possible to slide into the mount if I first spread the sides of the mount apart to push the switch down into the mount from the top just far enough in to get the nub into the channel, then slide the switch into place. Alternatively you can cut off the nub. <b> Mounting to the Rollcage (see pictures for better detail in how this mounts):</b> Upper side screw: Remove the appropriate countersunk screw on the roll cage,replace this screw with a M3x16mm screw and insert it through the upper screw of the switch/mount <i>If you want to attach the mount to the roll cage first before mounting the switch you may do so, but be sure to use a countersunk screw to allow enough room to slide the switch into place</i> Bottom side screw: Thread a M3x6mm or longer screw through the hole in the mount (since there is nothing for this screw to screw into you can leave it without a locknut and it acts as an alignment pin, or run a longer screw and add a locknut if you choose.