Speedy "Red Midi Swept Wing"

cults3d

This is a forward swept wing you can use with the fuselage of the "Speedy Red Midi Wing". The carbon rods pass all the way through, providing extraordinary stability. You need one 8 mm tube and one 5mm tube, each 1000mm long. These rods are so stiff and fit in so tightly, you don't need to glue anything. This makes changing a part very easy, in case it is broken or you want it in another color. I haven't had a chance myself to maiden it yet. Recommended Print Settings Attention The wings are designed to print using 0.5 mm width, 0.3 mm height, 3 bottom and 3 top layers, but one perimeter only. Should you print thinner walls, the perimeter of the upper side will not stick well enough to the perimeter of the inner stiffening construction. If you apply thicker walls, the perimeters will not come out continuously in one uninterrupted turn. The layers must build up as if you were printing in spiral vase mode. Only then you get a smooth surface on the upper side. If unsatisfied with the results, try out 0.49 or 0.48 width in your slices settings. It depends whether you use Cura, Slic3r, S3D or what you have. I suggest you experiment with some tests before printing the whole thing. The second point is: Should you print lesser layer heights, the inner stiffening construction will not connect well to the top and bottom layers. You will suffer a gap in between. All wing parts: layer height =0,3mm, width =0.5 mm wing: 1 perimeter, 3 bottom layers, 3 top layers, hollow wing servo: 3 bottom layers, 3 top layers, hollow elevon inner: 7 (!) bottom layers, spiral vase mode elevon outer: 3 bottom layers, spiral vase mode elevon joint: no bottom layer, spiral vase mode Specifications airfoil: AR2610-S80 modified wing span: 1000 mm wing chord: 200/128 mm aerodynamic center: 30 mm (12%) overall weight: 730 g wing weight 343 g (without components) wing weight complete: 374 fuselage weight complet 356 g fin weight 12 g wing area: 16.6 dm² wing loading: 44 g/dm² longitudinal stability (Thies) STFs: motor: Propdrive 28-36 1000KV static thrust: 950 g (3S Lipo) battery: Turnigy 1200 mAh 3S 40~50C Lipo motor camber: tilted -4 degrees side pull: none propeller: Aeronaut CAM Aeronaut Carbon Classic 10 x 6"